There’s nothing better on the market than a Lennox furnace. Youve tried everything to fix your furnace, looked at the thermostat and even changed out the air filter to see if that would help. But, If your system overheats or experiences a similar malfunction, you can simply reset your furnace. Here are the 4 steps needed to reset your Lennox furnace, Find your electrical panel and switch the breaker that controls your furnace, and have it up and running again in seconds. Below youll find out where your Lennox furnace reset button is and how to properly reset your furnace.
Watch our YouTube Video!
Check out our Cofounder, Josh Campbell, with Dave Lennox himself in our YouTube video!
How To Reset a Lennox Furnace
Step One:
Find your electrical panel and switch off the electrical supply to your furnace. This will eliminate the risk of any electrical injuries.
Flip the circuit breaker switch labeled “Furnace” or “Heating System” into the “Off” position.
Step Two:
Look at the control panel on your furnace. The control panel could be located on the bottom panel on downflow furnaces or the top panel on upflow models.
Once you find the control panel, lift the panel up and away from the appliance — you can set this aside for now.
Step Three:
Examine your furnace and look for a raised button or switch to the right of the ignition control box (or the “ Lennox limit switch reset”).
Press and release the limit control switch to rest your Lennox furnace.
Step Four:
To replace the furnace control access panel, follow these instructions in reverse.
Flip the “Furnace” or “Heating System” switch to the “On” position.
How to start and shut off a Lennox gas fireplace
FAQ
Why does my Lennox gas fireplace keep going out?
What to do if your Lennox fireplace is leaking gas?
Lennox Elite Lv Direct Vent Fireplace- Fireplace Pros from www.fireplacepros.com Consumers should immediately stop using the recalled gas fireplaces, turn off the gas to the fireplace and contact lennox hearth products for a free inspection and replacement of the leaking gas connector.
How do I Reset my Lennox Furnace?
Find the reset button The limit switch is located on the control panel side of many Lennox furnace models. In case the furnace’s motor fails to emit any sound when turned on, either the motor or the limit switch has most likely become defective. Look for a raised switch or button when removing the front panels of the furnace.
What should I do if my Lennox gas fireplace is recalled?
Consumers should immediately stop using the recalled gas fireplaces, turn off the gas to the fireplace and contact lennox hearth products for a free inspection and replacement of the leaking gas connector. We also will convert your gas.
How do you reset a gas fireplace?
To reset: Unplug the power cord from the outlet. Turn the Power Switch on the CONTROL PANEL to OFF. Wait at least 5 minutes. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to clean the vent areas. With the Power Switch in the OFF position, plug the power cord back into the outlet.